UTG Europe GmbH - Hunting/Shooting, Sporting Goods and Security Gear

UTG 4.2" ITA Red/Green T-Dot with QD Mount, Riser Adaptor
SCP-DS3840TDQ

UTG 6" ITA Red/Green CQB T-dot Sight with Offset QD Mount
SCP-TDTDQ

UTG 6" ITA Red/Green CQB Dot Sight With Offset QD Mount
SCP-TDSDQ

UTG 2.6" ITA Red/Green CQB Micro Dot with Integral QD Mount
SCP-DS3026W

UTG 4.2" ITA Red/Green CQB Dot with QD Mount, Riser Adaptor
SCP-DS3840W

UTG 3.9" ITA Red/Green CQB Dot Sight with Integral QD Mount
SCP-DS3039W

UTG 3.8" ITA Red/Green Single Dot Sight w/Integral QD Mount
SCP-RG40SDQ

UTG 3.8" ITA Red/Green Circle Dot Sight w/Integral QD Mount
SCP-RG40CDQ

UTG 3.8" ITA Red/Green CQB Dot Sight with Integral Mount
SCP-RD40RGW-A

In the past few years, Range Estimating reticle has begun to be recognized as a very useful tool by hunters and shooters around the world. With some patient learning and practices, this tool can enhance shooting accuracy and performance in ways not imagined before. Staying ahead of the trend, Leapers offers the most unique Range Estimating reticle, TRE, to our customers and continue to develop more for the future.

9 dots:

Regular mil-dot reticle found on the market usually has 4 dots on each direction of the cross hair, giving you 9 different aiming points for either windage or elevation. If you count the 2 inner tips of the opposite duplex cross hairs, you get 11 aiming points. Leapers’s own 36 Mil-Dot Reticle (TRE) has 9 dots on each direction of the cross hair, giving you 19 aiming points or 21 including the inner tips of the duplex cross hairs.

4 dots:

This is the regular mil-dot reticle with 4 dots on each direction of the cross hair, giving you 9 different aiming points for either windage or elevation. If you count the 2 inner tips of the opposite duplex cross hairs, you get 11 aiming points.

Mil-Dot Range Estimating:

Range estimating requires common knowledge/experience about your target's actual width or height.
Set your scope at 10X or the proper power, depending on the scope. View the target through the scope. Place the center of the dot against one edge of the target and measure to the opposite edge of the target.

Once the target has been measured in mils, depending on the scope model, a formula is available to estimate the distance of the target.
Each scope will come with a pre-calculated mil-dot table of most used distance estimates to aid the user.

Mil-Dot Range Estimating Example:

Height or Width of Target in Meters x 1,000		Magnification
	x		= Range in Meters (1 M = 1.0936 Yards)
Height or Width of Target in Mils		10

Hence, (1.016 x 1,000/9) X (9/10 ) = 101.6 meters (110 yds). Armed with this knowledge, you can compensate for the bullet’s drop accordingly and make “great things happen”!